search

Milan Technology E-FL-HB-0400 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Convertisseurs de médias en réseau Milan Technology E-FL-HB-0400. Milan Technology E-FL-HB-0400 User's Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Minneapolis, MN 55344 USA
10BASE-FL Ethernet
™
Unmanaged Fiber Hub with AUI, BNC or Fiber Uplink
E-FL-HB-0800, E-FL-HB-0400
USER’S GUIDE
The rack-mountable E-FL-HB-0800 and E-FL-HB-0400 series unmanaged
Ethernet™ fiber hubs allow the network administrator to set up network
workgroups connected over fiber and to install an OPTIONAL backbone
uplink adapter connection to the workgroups through 10BASE-5 AUI,
10BASE-2 BNC OR 10BASE-FL ST fiber connectors.
E-FL-HB-0800, E-FL-HB-0800(SC)
The E-FL-HB-0800 hub provides eight (8) Ethernet™ ST OR SC fiber
connections to terminal devices plus space at the back for an optional
backbone uplink adapter.
E-FL-HB-0400, E-FL-HB-0400(SC)
The E-FL-HB-0400 hub provides four (4) Ethernet™ ST OR SC fiber
connections to terminal devices plus space at the back for an optional
backbone uplink adapter.
BACKBONE UPLINK ADAPTERS Optional devices ordered separately that, when
installed, provide one of the following Ethernet
™
backbone uplink connections:
MA0A
•AUI connector to transceiver or to 10BASE-5 “thick-net” coaxial cable
MA0B
•BNC connector to 10BASE-2 “thin-net” coaxial cable
MA0F
•ST connector to multimode fiber
E-FL-HB-0x00 in the Network . . . . .2
Installation . . . . . . . . . . . . . . . . . . . .4
Operation . . . . . . . . . . . . . . . . . . . .11
Fault Isolation and Correction . . . .12
Cable Specifications . . . . . . . . . . . .14
Technical Specifications . . . . . . . . .15
Compliance Information . . . . . . . . .16
STAT
10BASE-FL
1
2
3
4
5
6
7
8
PWR
COL
ACT
BB
1
3
2
4
5
7
6
8
STAT
PWR
COL
ACT
BB
1
3
2
4
10BASE-FL
1
2
3
4
COMPLIANCE INFORMATION
UL Listed
C-UL Listed (Canada)
CISPR/EN55022 Class A
FCC Regulations
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user’s own expense.
Canadian Regulations
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on
the radio interference regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables
aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique
édicté par le ministère des Communications du Canada.
European Regulations
Warning
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Achtung !
Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes
Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen
werantwortlich ist.
Attention !
Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des
interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques
appropriées
VCCI Class 1 Compliance
This equipment is in the 1st Class category (information equipment to be used in commercial and/or
industrial areas) and conforms to the standards set by the Voluntary Control Council For Interference by
Data Processing Equipment and Electronic Office Machines aimed at preventing radio interference in
commercial and/or industrial areas. When used in a residential area or in an adjacent area thereto,
interference may be caused to radio and TV receivers, etc. Read the instructions for correct handling.
Trademark Notice
All registered trademarks and trademarks are the property of their respective owners.
Copyright Restrictions
© 1999 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
Printed in the U.S.A. 33160.A
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.
Vue de la page 0
1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - USER’S GUIDE

Minneapolis, MN 55344 USA10BASE-FL Ethernet™Unmanaged Fiber Hub with AUI, BNC or Fiber UplinkE-FL-HB-0800, E-FL-HB-0400USER’S GUIDEThe rack-mountabl

Page 2 - TECHNICAL SPECIFICATIONS

E-FL-HB-0x00 IN THE NETWORKInstall one E-FL-HB-0x00hub and use fiber cable toset up a workgroup byconnecting the hub toterminal devices.Install an op

Page 3 - CABLE SPECIFICATIONS

E-FL-HB-0x00 in Half-Duplex NetworkThe 5-4-3 Rule applies separately to each collision domain. NOTE: Acollision domain is any Carrier Sense Multiple A

Page 4 - INSTALLATION

INSTALLATION Optionally Install Backbone Uplink AdapterWARNING: Remove AC line cord from power source before installingbackbone uplink adaptor in E-FL

Page 5 - Install E-FL-HB-0x00 at Site

FAULT ISOLATION and CORRECTIONIf the E-FL-HB-0x00 fails, isolate and correct the fault by determining theanswers to the following questions and then t

Page 6 - OPERATION

Optionally Connect to Backplane THROUGH AUI UPLINKNOTE: Refer to 5-4-3 rule (page 3) to keep network configuration withinacceptable bounds.USING TRANS

Page 7 - Power the E-FL-HB-0x00

Power the E-FL-HB-0x00NOTE: When the hub is connected to an AC outlet supplying 100-240VAC at50-60 Hz, the hub automatically powers ON To power ON the

Page 8 - 1 2

Optionally Connect to Backplane (continued)THROUGH FIBER UPLINKTo connect fiber cable from E-FX-HB-xx00 10BASE-FLuplink adapter to network:1. Locate 1

Commentaires sur ces manuels

Pas de commentaire
Produits connexes et manuels pour Convertisseurs de médias en réseau Milan Technology E-FL-HB-0400
Convertisseurs de médias en réseau Milan Technology MIL-S341X Manuel d'utilisateur   (2 pages)
Convertisseurs de médias en réseau Milan Technology T1E1-CF-01(SM) Manuel d'utilisateur    (6 pages)
  • Brill Knaack West Penn Wire EMotimo Plasmon
  • Powermatic Scies à chaîne Sanyo TV LCD Artwizz Etuis pour téléphones portables NEC Papier photo Jenn-Air Fours
  • Vocera Badge Samsung HW-N300 AJA 4K2HD Canon Macro Twin Lite MT-24EX LG MS-192A
  • Husqvarna 927SBEXP Manuel de l'utilisateur Petzl TREESBEE Manuel de l'utilisateur Toshiba Pocket PC e310 Manuel de l'utilisateur Philips 12972PRB1 Fiche technique Samsung GT-C3590 Manuel de l'utilisateur